yangchi Button Switch Instruction Manual

yangchi Button Switch

Produk inligting

Produk Naam: Skakel oor
Bondel/reeksnommer: Knoppie skakelaar

Manufacturer & Eu Representative Info

Vervaardiger:
Maatskappy Naam: Guangzhou yangchi auto parts co. LTD
Adres: CN-2 # 1003 min joke Chuang, mining key ji yuan, tai he zhen, baryon district, Guangzhou.
E-pos: ouyan99@dingtalk.com
Telefoon: 86-13421389711
EU-gemagtigde verteenwoordiger:
Maatskappy Naam: CET PRODUCT SERVICE BPK
Adres: Osterholzallee 144 , 71636 Ludwigsburg Germany
E-pos: info.cetservice@gmail.com
Telefoon: Tel: +4971416432236

Nakomingsinligting

eVatmaster Consulting GmbH Bettinastr. 30 60325 Frankfurt am Main, Duitsland contact@evatmaster.com

OST_EU_20220224000026

Ons tree bloot op as verteenwoordiger van die Europese Kommissie vir grensoverschrijdende verkopers, en is nie vervaardigers/invoerders/verspreiders vir die produk nie, en ook nie betrokke by die vervaardiging/invoer/verkope van die produk nie. Daarom is ons nie verantwoordelik vir enige na-verkope dienste wat verband hou met die produk nie. In geval van enige produkkwaliteit- of oortredingskwessies, sal die vervaardiger/invoerder/verkoper alleen verantwoordelik gehou word.

LET WEL: This product must comply with all applicable safety and regulatory requirements in the market where it is sold. Sellers must assess which requirements and regulations apply based on the actual product type, function, and destination market.

Veiligheid en waarskuwings

Belangrike veiligheidsinligting

Read all instructions before use. Failure to follow these instructions may result in damage to the product or personal injury.\r\n·
Waarskuwing: Keep the device and its cord out of reach of children under 3 years old.\r\n· Keep away from children unless supervised by an adult.\r\n·
Do not use this product for purposes other than its intended use.\r\n· Inspect the product before each use; do not use if damaged.\r\n· Follow installation and operation guidelines to avoid injury.\r\n.

Instruksies vir gebruik

How to Replace a Faulty Window Switch:

Stap 1: Disconnect the negative battery terminal before working on the switch to prevent short circuit. Next, unclip the handles using a screw driver. Lift the faulty switch out of its harness.
Stap 2: If you don’t want to take off the door casing or the door handle, simply slide a flat-head screwdriver under The switch bezel and pry it until it loosens to access the housing.
Stap 3: Once the switch pops out of the bezel, disconnect it from the wire harness and detach it from the outlet. Remove the rockers before inserting a new switch into the harness holes.
Stap 4: Assemble the rockers into the new switch and snap the device into the bezel.