PERLESMITH TV Wall Mount Instruction Manual

Inleiding

This manual provides detailed instructions for the safe and correct installation and operation of your PERLESMITH TV Wall Mounts, including the PSMTK1 Tilting Mount and the PSMFK7 Full Motion Mount. Please read all instructions carefully before beginning installation to ensure proper setup and to prevent damage or injury.

Belangrike veiligheidsinligting

WAARSKUWING: Failure to read and follow all instructions can result in personal injury, property damage, or voiding of your warranty. If you do not understand these instructions or have doubts about the safety of the installation, please contact customer support.

• Do not install on drywall alone. The mount must be secured to a single wood stud, solid concrete, or brick wall.
• Maak seker dat die muurstruktuur die gekombineerde gewig van die montering en jou televisie veilig kan ondersteun.
• Gebruik altyd 'n assistent om die televisie op te tel en te posisioneer.
• Do not exceed the maximum weight capacity specified for each mount model.
• Check all connections and fasteners periodically to ensure they remain secure.

Pakketinhoud

Verify that all components are present and undamaged before installation. If any parts are missing or defective, contact PERLESMITH customer service.

PSMFK7 Full Motion TV Wall Mount Components

Image: The PSMFK7 full motion TV wall mount, showing the articulating arm, TV plate, wall plate, and small accessories like cable ties and a bubble level.

• Full Motion Wall Plate Assembly
• TV-hakies (x2)
• Mounting Hardware Kit (various screws, anchors, washers)
• Borrelvlak
• Kabelbinders

PSMTK1 Tilting TV Wall Mount Components

Image: The PSMTK1 tilting TV wall mount, showing the wall plate, TV brackets, and small accessories like cable ties and a bubble level.

• Tilting Wall Plate
• TV-hakies (x2)
• Mounting Hardware Kit (various screws, anchors, washers)
• Borrelvlak
• Kabelbinders

Opstelling en installasie

1. Pre-installasie tjeks

1. Verifieer TV-versoenbaarheid:
       For PSMFK7: Fits most 26"-55" TVs up to 70 lbs (31.8 kg) with VESA patterns from 100x100mm to 400x400mm.
       For PSMTK1: Fits most 23"-60" TVs up to 115 lbs (52 kg) with VESA patterns from 75x75mm to 400x400mm.
   

   Image: Visual guide for PSMFK7 compatibility, indicating TV size range, weight capacity, and VESA mounting patterns.
2. Identifiseer muurtipe: This mount is designed for installation on single wood studs, solid concrete, or brick walls. MOENIE op gips alleen installeer nie.
3. Check for Cable Blockage: Ensure the TV's power and input ports will not be blocked by the mounting brackets.

2. Attaching TV Brackets to TV

1. Plaas jou TV versigtig met die gesig na onder op 'n sagte, skoon oppervlak.
2. Select the correct screws, washers, and spacers from the hardware kit that fit your TV's VESA mounting holes.
3. Attach the two TV brackets to the back of your TV using the selected hardware. Ensure the brackets are level and securely fastened.

3. Montering van die muurplaat

1. Determine the desired height for your TV. Mark the drilling locations on the wall.
2. For Wood Stud Installation: Use a stud finder to locate the center of a wood stud. Drill pilot holes (e.g., 7/32" or 5.5mm) at the marked locations. Secure the wall plate using lag bolts and washers.
3. For Concrete/Brick Wall Installation: Drill pilot holes (e.g., 3/8" or 10mm) at the marked locations. Insert concrete anchors into the holes. Secure the wall plate using lag bolts and washers.
4. Use the included bubble level to ensure the wall plate is perfectly horizontal before tightening all fasteners.

4. Mounting TV to Wall Plate

1. With an assistant, carefully lift the TV with the attached brackets.
2. Hook the TV brackets onto the wall plate. Ensure the TV is securely seated on the mount.
3. For PSMFK7: Secure the TV to the mount using the safety screws or locking mechanisms provided.
4. For PSMTK1: Engage the locking mechanism with the quick release pull-down straps to secure the TV.


Image: Simplified installation steps for the PSMTK1 mount, illustrating how the TV brackets hook onto the wall plate and the use of the pull cord for locking and releasing.

Gebruik van jou TV-montering

PSMFK7 Full Motion Mount Adjustments

Image: Demonstrates the PSMFK7 mount's flexibility, including tilting down 15 degrees, extending up to 19.17 inches, swiveling 180 degrees, and leveling +/-3 degrees.

• Kantelverstelling: The mount features a +5°/-15° tilt range. Loosen the tilt knobs on the TV brackets, adjust the TV to the desired angle, and then tighten the knobs to secure.
• Swivel verstelling: The articulating arm allows for a +/-90° swivel. Gently push or pull the TV to the desired viewing hoek.
• Uitbreiding/Intrekking: Extend the TV up to 19.17 inches (48.7 cm) from the wall for optimal viewing or retract it back to 3.2 inches (8.1 cm) for a low-profile kyk.
• Nivelleringsaanpassing: After installation, you can make a +/-3° leveling adjustment to ensure the TV is perfectly horizontal.

PSMTK1 Tilting Mount Adjustments

• Kantelverstelling: The PSMTK1 allows for a downward tilt. Loosen the tilt bolts on the side of the TV brackets, adjust the TV to the desired angle, and then tighten the bolts.
• Sluitmeganisme: Use the pull-down straps to engage or disengage the quick-release locking mechanism, securing the TV to the wall plate.

Onderhoud

• Kontroleer gereeld alle skroewe en boute om te verseker dat hulle styf en stewig is.
• Maak die monteerstuk skoon met 'n sagte, droë lap. Vermy die gebruik van skuurmiddels of oplosmiddels.
• Ensure no cables are pinched or stressed by the mount's movement.

Probleemoplossing

• TV is nie gelyk nie: Use the leveling adjustment feature (PSMFK7) or re-adjust the tilt bolts (PSMTK1) and ensure the wall plate was installed level.
• Berging voel los: Re-check all wall plate and TV bracket fasteners. Ensure they are tightened securely. If installed on a wood stud, confirm the lag bolts are fully engaged in the stud. If on concrete, ensure anchors are properly seated.
• Difficulty moving full motion mount: Check for any obstructions. Ensure all pivot points are free of debris. If the movement is too stiff or too loose, some joints may have adjustable tension screws (refer to specific model diagrams if available).
• Ontbrekende dele: Do not proceed with installation. Contact PERLESMITH customer support for replacement parts.

Spesifikasies

Waarborg inligting

PERLESMITH products are manufactured with quality and care. For specific warranty details, please refer to the warranty card included with your product or visit the official PERLESMITH webwebwerf. Bewaar u aankoopbewys as bewys van aankoop.

Kliënte ondersteuning

If you have any questions, require assistance with installation, or need replacement parts, please contact PERLESMITH customer support. Our team is available to help you.

• Webwebwerf: www.perlesmith.com (Hypothetical link, please replace with actual if available)
• E-pos: support@perlesmith.com (Hypothetical email, please replace with actual if available)
• Telefoon: 1-800-XXX-XXXX (Hypothetical number, please replace with actual if available)