TC Electronic JUNE-60 CHORUS Pedal Instruction Manual

1. Inleiding

The TC Electronic JUNE-60 CHORUS pedal is an authentic recreation of the legendary synthesizer chorus from the 1980s. This pedal features a simple 2-button interface for intuitive modulation tone and utilizes all-analog BBD (Bucket Brigade Delay) circuitry to deliver its classic sound. Designed for guitarists seeking vintage chorus effects, the JUNE-60 CHORUS also includes True Bypass for ultimate signal integrity.

TC Electronic JUNE-60 CHORUS Pedal, top-down view

Figuur 1.1: Bo-na-onder view of the TC Electronic JUNE-60 CHORUS Pedal, showcasing its two yellow buttons and True Bypass footswitch.

2. Belangrike veiligheidsinstruksies

Lees hierdie instruksies deeglik deur voordat u die toestel gebruik.
Hou hierdie instruksies vir toekomstige verwysing.
Heed all warnings on the product and in the instructions.
Moenie hierdie toestel naby water of vog gebruik nie.
Maak slegs skoon met 'n droë lap.
Moenie enige ventilasie-openinge blokkeer nie. Installeer volgens die vervaardiger se instruksies.
Moenie naby enige hittebronne soos verkoelers, hitteregisters, stowe of ander toerusting (insluitend ampversterkers) wat hitte produseer.
Gebruik slegs aanhegsels/bykomstighede gespesifiseer deur die vervaardiger.
Verwys alle diens na gekwalifiseerde dienspersoneel. Versorging word vereis wanneer die apparaat op enige manier beskadig is, soos kragtoevoerkoord of prop beskadig is, vloeistof gemors is of voorwerpe in die apparaat geval het, die apparaat aan reën of vog blootgestel is, nie normaal werk nie. , of laat vaar is.

3. Opstelling

3.1 Kragverbinding

The JUNE-60 CHORUS pedal can be powered by a 9V battery or an external 9V DC power supply (not included). Ensure the power supply provides at least 100 mA. Connect the power supply to the 9V DC input jack on the rear of the pedal.

Batterykrag: To install a 9V battery, open the battery compartment on the bottom of the pedal. Connect the battery to the clip and place it inside the compartment.
Eksterne krag: Use a regulated 9V DC power supply with a center-negative plug, providing a minimum of 100 mA.

TC Electronic JUNE-60 CHORUS Pedal rear panel with input, output, and power jacks

Figure 3.1: Rear panel of the JUNE-60 CHORUS Pedal, showing the INPUT (MONO), 9V DC power input (100 mA), and OUTPUT (MONO/STEREO) jacks.

3.2 Oudioverbindings

Koppel jou instrument (bv. kitaar) aan die INPUT (MONO) jack using a standard 1/4-inch instrument cable. Connect the UITSET (MONO/STEREO) domkrag aan jou amplifier or the next pedal in your signal chain. For stereo operation, use a Y-cable or two separate cables from the output to two amplifiers or a stereo input device.

Mono-opstelling: Connect a single 1/4-inch cable from the OUTPUT jack to your amplewendiger.
Stereo-opstelling: The JUNE-60 CHORUS supports stereo output. Consult your amplifier or audio interface manual for proper stereo input connections.

4. Operasie

The JUNE-60 CHORUS pedal features a straightforward 2-button interface, replicating the classic chorus modes of its inspiration. The pedal is activated by the True Bypass footswitch.

4.1 Engaging the Effect

Druk die WARE VERWYP footswitch to toggle the effect on or off. When the effect is active, the LED indicator will illuminate.

4.2 Chorus Modes (Buttons I & II)

The two yellow buttons, labeled I en II, select different chorus modes. These buttons can be used individually or simultaneously to achieve distinct modulation characteristics.

Knoppie I: Engages Chorus Mode I, offering a specific modulation rate and depth.
Knoppie II: Engages Chorus Mode II, offering an alternative modulation rate and depth.
Buttons I & II (Simultaneously): Pressing both buttons together activates a combined chorus mode, often resulting in a richer, more complex modulation. Experiment with these combinations to find your desired sound.

TC Electronic JUNE-60 CHORUS Pedal top view showing buttons I and II

Figuur 4.1: Bo view of the JUNE-60 CHORUS Pedal, highlighting the two yellow buttons (I and II) for chorus mode selection.

4.3 Mono/Stereo Switch

A small switch labeled MONO / STEREO is located near the chorus mode buttons. This switch determines the output configuration of the pedal.

BOL: Vir enkellopende ampverligter opstellings.
STEREO: For dual amplifier or stereo input setups, providing a wider, more immersive chorus effect.

5. Onderhoud

5.1 Skoonmaak

Clean the pedal's exterior with a soft, dry cloth. Do not use abrasive cleaners or solvents, as these may damage the finish or internal components.

5.2 Batteryvervanging

If using battery power, replace the 9V battery when the effect LED dims or the pedal's performance degrades. To replace, open the battery compartment on the bottom of the unit, disconnect the old battery, and connect a new one, ensuring correct polarity.

5.3 Berging

When not in use for extended periods, disconnect the power supply and remove the battery to prevent leakage. Store the pedal in a cool, dry place away from direct sunlight and extreme temperatures.

6. Probleemoplossing

Probleem	Moontlike oorsaak	Oplossing
Geen geluid wanneer die pedaal ingetrap word nie.	No power, incorrect cable connection, faulty cable.	Check power supply connection and ensure it meets 9V DC, 100mA specifications. Replace battery if using battery power. Verifieer dat alle oudiokabels stewig gekoppel is. Test cables with another device to ensure they are not faulty.
Swak of verwronge klank.	Low battery, incorrect input level from instrument.	Replace battery or use external power supply. Ensure instrument output level is appropriate for pedal input.
Chorus effect is not noticeable.	Incorrect chorus mode selected, subtle setting.	Experiment with pressing Button I, Button II, or both simultaneously. Ensure the MONO/STEREO switch is set correctly for your setup.
Pedal does not power on with adapter.	Insufficient current from power adapter.	Verify your power adapter provides at least 100 mA at 9V DC. Some adapters may provide 9V but insufficient current.

7. Spesifikasies

Kenmerk	Detail
Model	JUNE-60 CHORUS
effek Tipe	Refrein
Kringloopbaan	All-analog BBD (Bucket Brigade Delay)
Omseil	Ware verbypad
Kontroles	2 x Chorus Mode Buttons (I, II), MONO/STEREO Switch, True Bypass Footswitch
Insette Connector	1 x 1/4" TS, unbalanced (Mono)
Uitgangskonnektor	1 x 1/4" TS, unbalanced (Mono/Stereo)
Krag Invoer	Standard 9V DC, center-negative, >100 mA (Power supply not included)
Battery opsie	9V battery (nie ingesluit nie)
Afmetings (H x B x D)	Ongeveer 13.7 x 8.6 x 5.6 duim
Gewig	8 onse (0.5 pond)
Liggaam Materiaal	Plastiek, metaal

TC Electronic JUNE-60 CHORUS Pedal bottom label with regulatory information

Figure 7.1: Bottom label of the JUNE-60 CHORUS Pedal, displaying model and regulatory compliance information.

8. Waarborg en Ondersteuning

8.1 Waarborginligting

TC Electronic products are designed and manufactured to the highest standards. For detailed warranty terms and conditions, please refer to the official TC Electronic webwebwerf of die waarborgkaart wat by u produk ingesluit is. Bewaar u bewys van aankoop vir enige waarborgeise.

8.2 Kliëntediens

Should you encounter any issues or have questions regarding your JUNE-60 CHORUS pedal, please visit the official TC Electronic support page for FAQs, troubleshooting guides, and contact information. You can find support resources at the TC Elektroniese Ondersteuning Webwebwerf.